Temperature and Humidity Sensor（WiFi） ZX EN
User Manual
English
You can search "Smart Life" in the mobile application store to install the App
Slide down the rear cover to open the device case. Then put two batteries into the product.
Use a pin to long press the reset button for at least 5 seconds and release, the device is ready to be paired when the LED flashes.
Open the App and click the "+" button on the upper right corner, then click the scan button in the "Add a device" panel and follow the instructions in the app to pair the device.
After the thermometer is paired, you can long press the device button on the main page of the App to inspect the thermometer status and view history data.
If you need to change the temperature unit of the sensor display, please enter the device panel and go to the device setting to make the change, then click the reset button with pin to make the unit change take effect.
Please note that the more frequent the sampling, the shorter the period or the smaller the threshold, the higher the power consumption will be, and consequently, the standby time will be reduced.
In the default scenario, the device operates in a low-power mode and performs temperature and humidity sampling every 15 minutes. It is estimated to have a battery life of approximately 6 months.
When performing an OTA upgrade, follow the steps below to ensure clarity and avoid any misunderstanding:
1.Power on the device and access the settings menu.
2.Scroll down within the settings menu until you find the "Device Update" option.
3..Tap on the "Update" option to initiate the upgrade process.
4.Obtain a reset pin or a similar tool.
5.Use the reset pin to continuously press the reset button on the device.
6.It is recommended to hold the reset button for approximately 2 seconds before releasing it, and then press it again.
7.Repeat this press-release cycle continuously until the upgrade is completed.
By following these steps, you will be able to perform the OTA upgrade smoothly, without any confusion or misunderstanding.
Installation method: Use a 3M sticker to affix the product to a proper position.
The automation function is available in the App to connect different devices. Each automation contains a series of trigger conditions and target actions. The target actions will be automatically triggered when the conditions are met.To set up an automation, click the “+” button in the upper right corner of the automation page. You can use the thermometer as a trigger condition and create target actions with other appliances.
Dimensions: 51 x 51 x 16.5 mm
Weight: 22 g
Recommended temperature range: -9.9 °C - 60 °C/ 14℉～140℉
Recommended humidity range: 5 %RH – 95 %RH
Wireless protocol: 2.4GHz Wi-Fi
Working voltage: DC 3V
Battery type: AAA